魏利勝 江 明
(1.安徽工程大學,安徽 蕪湖 241000;2.上海大學,上海 200072)
多變量網絡控制系統魯棒容錯控制研究
魏利勝1,2江 明1
(1.安徽工程大學,安徽 蕪湖 241000;2.上海大學,上海 200072)
文章研究了一類具有時延和丟包且執行器故障的多變量網絡控制系統魯棒容錯控制器設計問題,基于系統中的不確定性,推導了該類網絡控制系統的誘導時滯數學模型,并利用李雅普諾夫第二法和自由權矩陣方法,分析了系統的漸近穩定性,得到了系統穩定運行的最大允許時延的條件。最后,通過仿真分析證實了本文所提理論的有效性,以及穩定判據的可行性。
網絡控制系統;容錯;線性矩陣不等式;自由權矩陣
自上世紀90年代以來,隨著通信、控制、計算機等技術的發展,基于網絡的控制系統已成為自動化領域技術發展的熱點[1-3],這種控制模式具有成本低、連線少、易于安裝維護等優點,已經廣泛應用于工業經濟各領域[1]。國內外很多學者在網絡控制系統建模以及穩定性分析方面做了大量的研究[2-7],但實際工業應用過程中普遍存在不確定性對象、干擾甚至是傳感器或執行器出現故障等現象,因此,研究網絡控制系統魯棒容錯控制問題顯得非常重要。
目前,網絡系統的容錯控制研究還是一個嶄新的課題,對這方面的研究成果還很有限,相關文獻尚不多見[8-14]。華中科技大學方華京教授在這方面作了一些探索性的工作,其中文獻[13]考慮網絡誘導時延的隨機性,研究了離散網絡控制系統執行器失效的容錯控制問題,但沒有考慮系統中的不確定性;文獻[14]針對有界網絡時延系統,研究了離散網絡控制系統執行器失效的魯棒容錯控制;另外Zhang等[15]針對定常時延網絡控制系統研究其魯棒容錯控制器。以上研究主要基于離散系統或定常時延系統進行研究的,且沒有考慮網絡丟包現象,所得結論相對較為保守,因此,本文將在已有的網絡化控制系統容錯控制理論研究成果的基礎上,綜合考慮由于建模誤差、網絡環境因素、元器件老化等原因導致的不確定性,以及網絡丟包現象,引入自由權矩陣方法,并借助跳變系統理論,研究連續多變量網絡控制系統中執行器存在失效情況下的魯棒容錯控制問題,并給出仿真示例以證明所提方法的有效性,為網絡控制系統的研究提供一條新思路。
本文主要考慮如下不確定參數線性多變量連續的被控對象,
其中:x(t)∈Rn,u(t)∈Rm,y(t)∈Rr分別表示網絡控制系統被控對象的狀態、輸入、輸出;系統系數矩陣A、B、C為具有適當維數的常數實矩陣;τ為網絡控制系統的最大允許綜合界;△A、△B是反映模型中不確定參數的未知實數矩陣,假定其范數有界,且具有以下形式:
現根據容錯控制的思想,設計一個魯棒控制器增益K,使多變量網絡控制系統在正?;蚬收蠗l件下都能保持系統穩定且具有良好的控制性能。
在考慮執行器失效情況下系統的完整性設計過程中,可借助跳變系統理論,引入執行器狀態開關矩陣,如下:
其中:Θa表示所有可能的執行器失效開關矩陣La的集合。
成立,則對所有滿足式(2)的不確定性以及執行器失效的情況下,網絡控制系統(8)是漸近穩定的。
而利用文獻[12]中的定理1得到系統的最大可容忍時延為τmax=87.1ms(小于本文定理1所計算的最大可容忍時延164.3ms),可見本文采用自由權矩陣的方法有效降低了系統的保守性。
假設系統的初試狀態為[1,0.5,-0.5,-1]時,利用Matlab仿真軟件得到執行器存在故障的情況下的網絡控制系統狀態響應曲線如圖1-圖3所示。
圖1 執行器無故障時狀態響應曲線
圖2 執行器1故障時狀態響應曲線
圖3 執行器2故障時狀態響應曲線
可見,本文引入自由權矩陣方法來設計多變量網絡控制系統中執行器存在失效情況下的魯棒容錯控制器能有效保證系統的漸近穩定性。
本文針對執行器“故障”的時變特性,通過引入Lyapunov-Krasovskii泛函和自由權矩陣變量技術,利用容錯控制和切換系統的理論,給出了時延依賴的系統魯棒穩定性條件,得出了系統的魯棒容錯控制策略,通過仿真實驗表明,本文所采用方法有效降低了穩定條件的保守性,這些結果對于研究網絡化環境下多變量被控對象的魯棒容錯控制問題具有一定的理論指導意義。但本方法依然存在一定的保守性,如何合理選取自由權矩陣變量參數,以降低系統魯棒條件的保守性,這將有待于日后進一步研究。
[1]Gupta,R.A,Mo-Yuen Chow.Networked Control System:Overview and Research Trends[J].IEEE Transactions on Industrial Electronics,2010,57(7):2527-2535.
[2]Yun-Bo Zhao,Guo-Ping Liu,Rees,D.Packet-Based Deadband Control for Internet-Based Networked Control Systems[J].IEEE Transactions on Control Systems Technology,2010,18(5):1057-1067.
[3]Xiefu Jiang,Qing-Long Han,Shirong Liu,Anke Xue.New Stabilization Criterion for Networked Control Systems[J].IEEE Transactions on Automatic Control,2008,53(4),pp:1025-1032.
[4]Shi-Lu Dai,Hai Lin,Shuzhi Sam Ge.Scheduling-and-Control Codesign for a Collection of Networked Control Systems With Uncertain Delays[J].IEEE Transactions on Control Systems Technology,2010,18(1):66-78.
[5]Dong Yue,Q-L Han,Chen Peng.State feedback controller design of networked control systems[J].IEEE Trans on Circuits and Systems-II,2004,51(11):640-644.
[6]Heemels,W.P.M.H,Teel,A.R,van de Wouw,N,Nesic?,D.Networked Control Systems With Communication Constraints:Tradeoffs Between Transmission Intervals,Delays and Performance[J].IEEE Transactions on Automatic Control,2010,55(8):1781-1796.
[7]L.Wei,M.Jiang,and M.Fei.Robust Stability of Multi-variable Networked Control Systems with Random Time Delay[J].Lecture Notes in Computer Science,2009,5854:586-595.
[8]HUO Zhi-hong,FANG Hua-jing.Fault-tolerant Control of Networked Control Systems with Random Time-delays[J].Information and Control,35(5):584-587.
[9]Patankar,R.P.A model for fault-tolerant networked control system using TTP/C communication[J].IEEE Transactions on Vehicular Technology,2004,53(5):1461-1467.
[10]He Huang,Xiaodong Han,Xiaopeng Ji,Zhiquan Wang.Faulttolerant Control of Networked Control System with Packet Dropout and Transmission delays[C].IEEE International Conference on Networking,Sensing and Control,Sanya,China,6-8 April,2008:325-329.
[11]Yuquan Zhang,Qiuhai Zhong,Yan Wang,Kai Zheng.Faulttolerant design for MIMO networked control systems with communication constraints[J].Chinese Control and Decision Conference 2008,Yantai,China,2-4 July 2008:1380-1384.
[12]郭一楠,張芹英,鞏敦衛,張建化.一類時變時延網絡控制系統的魯棒容錯控制[J].控制與決策,2008,23(6):689-692,696.
[13]霍志紅,方華京.一類隨機時延網絡控制系統的容錯控制研究[J].信息與控制,2006,35(5):584-587.
[14]鄭英,方華京.不確定網絡控制系統的魯棒容錯控制[J].西安交通大學學報,2004,38(8):804-807.
[15]Zhang Jian-hua,Gong Dun-wei,Guo Yi-nan.Robust fault-tolerant control for networked control systems[C].The 1st International Conference on Complex System and Applications.Huhhot,China,15-18 June,2006:445-458.
[16]Gu K.A further refinement of discretized Lyapunov functional method for the stability of time-delay systems[J].International Journal of Control,2001,74(10):967-976.
[17]Peterson I R,Hollot C V.A Riccati equation approach to the stabilization of certain linear systems[J].Automatica,1986,22(4):397-411.
[18]俞立.魯棒控制-線性矩陣不等式處理方法[M].北京:清華大學出版社,2002.
Research on Fault-tolerant Control Methodology for Multi-variable NCSs
Wei Li-sheng1,2,Jiang Ming1
(1.Anhui Polytechnic University,Wuhu Anhui 241000,China;2.Shanghai University,Shanghai 200072,China)
The issue of fault-tolerant control for uncertain continuous-time multi-variable networked control systems with actuators failure is researched,where its network transmission is connected with network-induced delay and packet dropout.The complete mathematical model is derived.And the sufficient condition for asymptotical stability is analyzed and the maximum allowable delay conditions for systems are derived by using Lyapunov stability theory combined with free-weighting matrices techniques.The efficacy and feasibility of the proposed methods is shown by presenting simulation results from multi-variable networked control example with uncertainty.
Networked control systems(NCSs);fault tolerant;LMI;free-weighting matrices
TP273
A
1672-0547(2011)03-0109-04
2011-03-24
魏利勝(1978-),男,安徽巢湖人,安徽工程大學電氣工程學院講師,博士,研究方向:網絡控制系統;
江 明(1965-),男,安徽蕪湖人,安徽工程大學教授,研究方向:智能控制。
上海市電站自動化技術重點實驗室開放基金項目(編號:09DZ2273400),安徽省高校自然科學基金項目(編號:KJ2011B010),安徽工程大學引進人才科研啟動基金計劃項目(編號:2009YQQ003)研究成果。